Cable for Heater Flap Automatic Heater Porsche 911 (74-89)

Connecting cable between the heater's servo motor and the heater flaps. Specifically for vehicles with automatic heating control.

• Heater cable for flap control
• System: Only for Automatic Heating (Auto-Heat)
• Connects the servo motor to the heat exchangers
• Suitable for: Porsche 911 G-Model & Turbo
• Available for model years: 1974–86 or 1987–89

This cable is the crucial connecting element for the automatic heating control (Heiztronic) in the Porsche 911. It transmits the movement of the electric servo motor (usually mounted between the front seats) to the heater flaps on the heat exchangers in the rear.

If this cable is torn or stretched, the servo motor will be audible, but the heater flaps will not open, and the interior will remain cold (or the heating can no longer be switched off). Since manual heating systems and automatic climate control systems use different cables, this part is exclusively suitable for vehicles with the factory option "Automatic Heating".

Technical Data

• Type: Bowden cable / wire rope
• Installation location: From the interior (center tunnel) to the heater flaps
• Usage: Replacement for defective cables in Auto-Heat systems

Compatibility

Please pay attention to your vehicle's model year, as there are different versions depending on the model update:

• Porsche 911 G-Model – 1974 to 1986 or 1987 to 1989
• Porsche 911 Turbo (930) – 1974 to 1986 or 1987 to 1989

Scope of Delivery

• 1 × Heater flap cable (for automatic heating)

Note

Please check the model year carefully before ordering, as the lengths of the cables may have changed in 1987 (with the introduction of the G50 transmission and modified heating technology).